OMRON CPM1A-10CDT-A-V1 Programmable Controller

OMRON CPM1A-10CDT-A-V1 PROGRAMMABLE CONTROLLER

Product Details

One-piece Construction: The CPM1A CPU Units feature a one-piece construction including 10, 20, 30, or 40 built-in I/O terminals. The following three model groups are available: relay output models, sinking transistor output models, and sourcing transistor output models.

Extra I/O Capacity: Up to three Expansion I/O Units can be connected to a CPM1A-30CD-(-V1)

or CPM1A-40CD-(-V1) CPU Unit to add an extra 8 or 20 I/O points for each, for a maximum of up to 100 I/O points.

Input Filter Function: The CPM1A is equipped with a filter function to prevent incorrect operation

caused by chatter or noise in the input signal. The user can select an input time constant of 1 ms, 2 ms, 4 ms, 8 ms, 16 ms, 32 ms, 64 ms, or 128 ms.

Low-maintenance Design: Flash memory provides memory backup without a battery. Input Interrupts The CPM1A-10CD-(-V1) CPU Units can handle 2 interrupt inputs; the CPM1A-20CD-(-V1), CPM1A-30CD-(-V1), and CPM1A-40CD-(-V1) CPU Units can handle 4 interrupt inputs. In addition to normal input interrupts, the CPM1A has a counter mode that counts high-speed input signals and triggers interrupts at fixed count multiples.

Quick-response Inputs: Quick-response inputs can detect input signals with a pulse width as short as 0.2 ms regardless of their timing during the PC cycle. Quick-response inputs and interrupt inputs use the same input terminals.

Interval Timer: CPM1A PCs have a high-speed interval timer which can be set from 0.5 ms to

319,968 ms. The timer can be set to trigger a single interrupt (one-shot mode) or repeat scheduled interrupts (scheduled interrupt mode).

High-speed Counter: CPM1A PCs have a high-speed counter that can be used in incremental mode or up/down mode. The high-speed counter can be combined with input interrupts to perform target value control or zone comparison control that isn’t affected by the PC’s cycle time.

Pulse Output Function: The CPM1A transistor output models have an output function capable of outputting a pulse of 20 Hz to 2 kHz (single-phase output).

Analog Setting Function: The CPM1A PCs have 2 analog volume controls that can be used to make manual analog settings.

Moore News

NONFERROUS INDUSTRY
Non-ferrous Industry Capability
The sintering method and the Bayer process are currently the main methods for industrial production of alumina. Most of the alumina produced is produced by Bayer process.The Bayer-sintering hybrid method was first created, which greatly improved the total recovery of alumina.
With the continuous improvement of production technology, some new production methods such as lime Bayer method and beneficiation Bayer method are continuously applied to production.
The integrated process control system is a distributed control system.
The system consists of eight process control subsystems (workshop) for raw material grinding, lime digestion, dissolution, sedimentation, seed filtration, evaporation, product filtration, and roasting. Each workshop has an engineering station EWS and 2-3 operator stations OPS.
The data collection, real-time monitoring, data processing and other information transmission of the internal process parameters of the workshop are realized by the EtherNet/IP control network. The main production operations of the entire alumina plant are completed by these eight subsystems, each controlled by a ControlLogix controller.

More Products

Contact Us

miya@mvme.cn(Click)

Email: miya@mvme.cn

QQ: 2851195450

Tel: 86-18020776792

Skype: miyazheng52

mitsubishi motion controller

b&r touch screen

OMRON CPM1A-10CDT-A-V1 Programmable Controller Images